Allied Telesis AT-S95 CLI - Manual (Page 131)

IGMP Snooping Commands
Page 131
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
The leave timeout should be set greater than the maximum time that a host is allowed to respond to an IGMP
query.
Use immediate leave only where there is just one host connected to a port.
Example
The following example configures the host leave-time-out to 60 seconds.
show ip igmp snooping mrouter
The show ip igmp snooping mrouter User EXEC mode command displays information on dynamically learned
Multicast device interfaces.
Syntax
show ip igmp snooping mrouter [interface vlan-id]
Parameters
•
vlan-id — VLAN number.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays Multicast device interfaces in VLAN 1000.
console(config)# interface vlan 2
console(config-if)# ip igmp snooping leave-time-out 60
console> show ip igmp snooping mrouter interface 1000
VLAN Ports
---- -----
1000 1/e1
Detected Multicast devices that are forbidden statically: