Allied Telesis AT-S95 CLI - Manual (Page 145)

IPv6 Addressing Commands
Page 145
Chapter 12.IPv6 Addressing Commands
ipv6 enable
The ipv6 enable Interface Configuration mode command enables IPv6 processing on an interface. Use the no
form of this command to disable IPv6 processing on an interface.
Syntax
ipv6 enable [no-autoconfig]
no ipv6 enable
Parameters
•
no-autoconfig — Enables IPv6 processing on an interface without the stateless address autoconfiguration
procedure.
Default Configuration
IPv6 is disabled.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
The ipv6 enable command automatically configures an IPv6 link-local unicast address on the interface while also
enabling the interface for IPv6 processing. The no ipv6 enable command removes the entire IPv6 interface
configuration.
Example
The following example enables IPv6 processing on VLAN 1.
ipv6 address
The ipv6 address Interface Configuration mode command sets an IPV6 address. Use the no form of this
command to remove an IPV6 address from the interface.
Syntax
ipv6 address ipv6-address/prefix-length [eui-64] [anycast]
no ipv6 address [ipv6-address/prefix-length] [eui-64]
console(config)# interface vlan 1
console(config-if)# ipv6 enable