Allied Telesis AT-S95 CLI - Manual (Page 170)

Page 170
Allied Telesis
AT-S95 Management Software CLI User’s Guide
Chapter 16.LLDP Commands
lldp enable (global)
The lldp enable Global Configuration mode command enables the Link Layer Discovery Protocol (LLDP). Use the
no form of this command to disable LLDP.
Syntax
lldp enable
no lldp enable
Parameters
This command has no parameter settings.
Default Configuration
LLDP is enabled.
Command Mode
Global Configuration mode.
User Guidelines
There are no guidelines for this command.
Example
The following example enables LLDP.
lldp enable (interface)
The lldp enable Interface Configuration mode command enables LLDP on an interface. Use the no form of this
command to disable LLDP on an interface.
Syntax
lldp enable [rx|tx|both]
no lldp enable
Parameters
•
rx — Receives only LLDP packets.
• tx —Transmits only LLDP packets.
• both — Receives and transmits LLDP packets (default).
console (config)# lldp enable