Allied Telesis AT-S95 CLI - Manual (Page 116)

Page 116
Allied Telesis
AT-S95 Management Software CLI User’s Guide
Syntax
port storm-control broadcast enable
no port storm-control broadcast enable
Parameters
This command has no arguments or keywords.
Default Configuration
Broadcast storm control is disabled.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
Use the port storm-control broadcast rate Interface Configuration (Ethernet) mode command, to set the
maximum allowable Broadcast rate.
Use the port storm-control include-multicast Interface Configuration (Ethernet) mode command to enable
counting Multicast packets and optionally unknown Unicast packets in the storm control calculation.
Examples
The following example enables Broadcast storm control on Ethernet port 1/e5.
port storm-control broadcast rate
The port storm-control broadcast rate Interface Configuration (Ethernet) mode command configures the
maximum Broadcast rate. Use the no form of this command to return to the default configuration.
Syntax
port storm-control broadcast rate rate
no port storm-control broadcast rate
Parameters
•
rate — Maximum kilobits per second of Broadcast and Multicast traffic on a port. (Range: 70 - 100000)
Default Configuration
The default storm control Broadcast rate is 3500 Kbits/Sec.
Command Mode
Interface Configuration (Ethernet) mode
console(config)# interface ethernet 1/e5
console(config-if)# port storm-control broadcast enable