Allied Telesis AT-S95 CLI - Manual (Page 148)

Page 148
Allied Telesis
AT-S95 Management Software CLI User’s Guide
Example
The following example defines an IPv6 default gateway.
show ipv6 interface
The show ipv6 interface Privileged EXEC mode command displays the usability status of configured IPv6
interfaces.
Syntax
show ipv6 interface [vlan vlan-id]
Parameters
•
vlan vlan-id — Valid VLAN numbers (VLAN 1 only).
Default Configuration
Displays all IPv6 interfaces.
Command Mode
Privileged EXEC mode.
User Guidelines
To display IPv6 neighbor discovery cache information, use the show ipv6 neighbors command in the Privileged
EXEC mode.
Examples
The following examples display the usability status of interfaces configured for IPv6.
console(config)# ipv6 default-gateway fe80::11
console# show ipv6 interface
Interface IP addresses Type
--------- ---------------------------- ----------
VLAN 1 FE80::9C0:876A:130B Dynamic
VLAN 17 FE80::9C0:876A:130D Dynamic
VLAN 17 2031:0:130F:0:0:9C0:876A:130D/64 Static
console# show ipv6 interface Vlan 15
Ipv6 is disabled
console# show ipv6 interface Vlan 25
Number of ND DAD attempts: 20
IP addresses Type DAD State