Allied Telesis AT-S95 CLI - Manual (Page 166)

Page 166
Allied Telesis
AT-S95 Management Software CLI User’s Guide
lacp timeout
The lacp timeout Interface Configuration (Ethernet) mode command assigns an administrative LACP timeout.
Use the no form of this command to return to the default configuration.
Syntax
lacp timeout {long | short}
no lacp timeout
Parameters
•
long — Specifies the long timeout value.
• short — Specifies the short timeout value.
Default Configuration
The default port timeout value is long.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example assigns a long administrative LACP timeout to Ethernet port 1/e6 .
console(config)# interface ethernet 1/e6
console(config-if)# lacp timeout long