Allied Telesis AT-S95 CLI - Manual (Page 322)

Page 322
Allied Telesis
AT-S95 Management Software CLI User’s Guide
Default Configuration
The automatically configured unit number is assigned.
Command Modes
Global Configuration mode
User Guidelines
This command is not relevant to standalone devices.
The command takes effect only after resetting the device.
Example
This example changes Unit Number 6 to Unit Number 5. The command takes effect only after resetting the device.
show stack
Note
This command is operational in the AT-S94/24, AT-S94/24POE, AT-S94/48 and AT-S94/48POE devices.
The show stack User EXEC mode command displays information about the status of a stack.
Syntax
show stack [unit unit]
Parameters
•
unit — Specifies the number of the unit. (Range: 1 - 6)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command is not relevant to standalone devices.
Example
The following example displays stack status
console# config
console(config)# stack change unit-id 6 to 5
console> show stack
Unit
MAC Address Software Master Uplink Downlink Status