Allied Telesis AT-S95 CLI - Manual (Page 117)

Ethernet Configuration Commands
Page 117
User Guidelines
Use the port storm-control broadcast enable Interface Configuration mode command to enable Broadcast
storm control.
The software displays the actual rate since granularity depends on the requested rate.
Example
The following example configures the maximum storm control Broadcast rate at 900 Kbits/Sec.
show ports storm-control
The show ports storm-control User/Privileged EXEC mode command displays the storm control configuration.
show ports storm-control [interface]
Parameters
•
interface — A valid Ethernet port. (Full syntax: unit/port)
Default Configuration
This command has no default configuration.
Command Modes
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the storm control configuration.
console(config)# interface ethernet 1/e5
console(config-if)# port storm-control broadcast rate 900
console# show ports storm-control
Port
State Rate [Kbits/Sec] Included
---- -------- ---------------- --------------------------------------
1/e1 Enabled 70 Broadcast, Multicast
1/e2 Enabled 100 Broadcast
1/e3 Disabled 100 Broadcast