Allied Telesis AT-S95 CLI - Manual (Page 37)

ACL Commands
Page 37
Parameters
•
input — Applies the specified ACL to the input interface.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
In advanced mode, when an ACL is bound to an interface, the port trust mode is set to trust 12-13 and not to 12.
Example
The following example, binds (services) an ACL to Ethernet interface e2.
show access-lists
The show access-lists Privileged EXEC mode command displays Access Control Lists (ACLs) configured on the
switch.
Syntax
show access-lists [name]
Parameters
•
name — Name of the ACL.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays access lists.
console(config)# interface ethernet e2
console(config-if)# service-acl input macl1
console# show access-lists
IP access list ACL1
permit ip host 172.30.40.1 any
permit rsvp host 172.30.8.8 any