Allied Telesis AT-S95 CLI - Manual (Page 107)

Ethernet Configuration Commands
Page 107
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
In the following example enable flow control on cascade ports.
clear counters
The clear counters EXEC mode command clears statistics on an interface.
Syntax
clear counters [ethernet ethernet | port-channel port-channel-number]
Parameters
•
ethernet — Valid Ethernet port. (Full syntax: unit/port)
• port-channel-number — Valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode or Privileged EXEC Mode
User Guidelines
There are no user guidelines for this command.
Example
In the following example, the counters for interface 1/e1 are cleared.
set interface active
The set interface active Privileged EXEC mode command reactivates an interface that was shutdown.
Syntax
set interface active {ethernet interface | port-channel port-channel-number}
console(config)# system flowcontrol
console> clear counters ethernet 1/e1