Allied Telesis AT-S95 CLI - Manual (Page 104)

Page 104
Allied Telesis
AT-S95 Management Software CLI User’s Guide
Example
The following example configures the duplex operation of Ethernet port 1/e5 to full duplex operation.
negotiation
The negotiation Interface Configuration (Ethernet, port-channel) mode command enables auto-negotiation
operation for the speed and duplex parameters of a given interface. Use the no form of this command to disable
auto-negotiation.
Syntax
negotiation [capability1 [capability2…capability5]]
no negotiation
Parameters
•
capability — Specifies the capabilities to advertise. (Possible values: 10h, 10f, 100h,100f, 1000f)
Default Configuration
Auto-negotiation is enabled.
If unspecified, the default setting is to enable all capabilities of the port.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
If capabilities were specified when auto-negotiation was previously entered, not specifying capabilities when
currently entering auto-negotiation overrides the previous configuration and enables all capabilities.
Example
The following example enables auto-negotiation on Ethernet port 1/e5.
flowcontrol
The flowcontrol Interface Configuration (Ethernet, port-channel) mode command configures flow control on a
given interface. Use the no form of this command to disable flow control.
Syntax
flowcontrol {on | off | auto}
no flowcontrol
console(config)# interface ethernet 1/e5
console(config-if)# duplex full
console(config)# interface ethernet 1/e5
console(config-if)# negotiation