Campbell Scientific CR200/CR200X-series Dataloggers - Manual (Page 75)

Section 8. CR200(X) Configuration
double clicking on a value cell with the mouse. The grid will not allow read-
only settings to be edited.
The bottom of the Settings Editor displays help for the setting that has focus on
the top of the screen.
Once a setting is changed, click Apply or Cancel. These buttons will only
become enabled after a setting has been changed. If the device accepts the
settings, a configuration summary dialogue is shown ( FIGURE. Summary of
CR200(X) Configuration p. 63) that gives the user a chance to save and print the
settings for the device.
Figure 41: Summary of CR200(X) Configuration
Clicking the Factory Defaults button on the Settings Editor will send a
command to the device to revert to its factory default settings. The reverted
values will not take effect until the final changes have been applied. This button
will remain disabled if the device does not support the DevConfig protocol
messages.
Clicking Save on the summary screen will save the configuration to an XML
file. This file can be used to load a saved configuration back into a device by
clicking Read File and Apply.
63