Campbell Scientific CR200/CR200X-series Dataloggers - Manual (Page 120)

Section 10. CRBASIC Programming Instructions
10.12 Satellite Systems Programming
Instructions for GOES. Refer to satellite transmitter manuals available at
www.campbellsci.com .
10.12.1 GOES
The CR295 and CR295X dataloggers support communication through Campbell
Scientific’s TX312 or HDR GOES satellite transmitters. The CR295(X) has an
extra 9-pin serial port. The CR295 requires a special operating system and does
not support radio telemetry or calculation of evapotranspiration and is not CE
compliant. The CR295X has the same operating system and expanded
capabilities as other CR200(X) series dataloggers.
CRBASIC instructions used by the CR295(X) are:
GOESData
Sends data to a CSI GOES satellite data transmitter.
Syntax
GOESData (Dest, Table, TableOption, BufferControl,
DataFormat)
GOESGPS
Stores GPS data from the satellite into two variable arrays.
Syntax
GOESGPS (GoesArray1(6), GoesArray2(7))
GOESSetup
Programs the GOES transmitter for communication with the satellite.
Syntax
GOESSetup (ResultCode, PlatformID, MsgWindow,
STChannel, STBaud, RChannel, RBaud, STInterval,
STOffset, RInterval)
GOESStatus
Requests status and diagnostic information from a CSI GOES satellite
transmitter.
Syntax
GOESStatus (Dest, StatusCommand)
108