Campbell Scientific CR200/CR200X-series Dataloggers - Manual (Page 190)

Appendix B. Status Table and Settings
Table 27. CR200(X) Settings
Settings are accessed through Campbell Scientific's Device Configuration Utility (DevConfig) for direct serial
connection, or through PakBusGraph for most telecommunications options.
Setting Description Default Entry
Max Packet Size Specified the maximum size packet in bytes that should ever be
sent to the device.
1000
PakBus Address This setting specifies the PakBus® address for this device. The
value for this setting must be chosen such that the address of
the device is unique in the scope of the datalogger network.
Duplication of PakBus® addresses in two or more devices can
lead to failures and unpredictable behavior in the PakBus®
network. The following values are the default addresses of
various types of software and devices and should probably be
avoided:
Device PB Address
LoggerNet 4094
PC400 4093
PC200 4092
Visual Weather 4091
RTDAQ 4090
DevConfig 4089
NL100 678
All other devices 1
1
Radio Installed Specifies the model number of the MaxStream radio if it is
recognized by the datalogger. It will have a value of zero if
there is no radio recognized by the datalogger.
RF Network Address Specifies the radio network address of the built-in radio. This
setting should be set to match the network address for the
RF400 base used to communicate with the datalogger.
0
RF Address Specifies the address of the built-in radio. This value should
generally be set to match the same as the address of the
RF400 base used to communicated with the datalogger unless
that base is used to communicate with non-PakBus®
dataloggers (such as a CR10X).
0
RF Hop Sequence Specifies the hopping sequence that will be used for the built-in
radio. This value should be set to match the value of the same
setting for the RF400 base station used to communicate with
this datalogger
0
Ignore RF Power Mode If set to true (non-zero value), the RF power mode setting will
be ignored and the radio will be powered on all of the time.
0
RF Power Mode This setting specifies the power wait state that will be set in the
built-in radio. This setting must be set so that the standby mode
of the radio is consistent with any other CR200(X) or
RF400/RF410/Rf415 with which this station must communicate.
The power modes supported include the following:
No Radio
Indicates that there is no radio hardware recognized by the
datalogger. The datalogger will not accept this value as an
input, but will report it if there is no radio hardware detected.
Always On
Indicates that the radio receiver circuit should always be ready
to receive data.
50
18