Campbell Scientific CR200/CR200X-series Dataloggers - Manual (Page 199)

Appendix E. Antenna Usage and
Compliance
E.1 Use of Antenna with CR200(X)
An FCC authorized antenna is required for use with CR200(X) models that have
a built-in radio. Several models are available from Campbell Scientific.
These antennas have been tested at an authorized FCC open-field test site and
are certified to be in compliance with FCC emissions limits. All antennas or
antenna cables have an SMA female connector for connection to the CR200(X).
The use of an unauthorized antenna could cause transmitted field strengths in
excess of FCC rules, interfere with licensed services, and result in FCC
sanctions against user.
E.2 Part 15 FCC Compliance Warning
Changes or modifications to the CR200(X) series radio systems not expressly
approved by Campbell Scientific, Inc. could void the user’s authority to operate
this product.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
27