Horner APG RX371 OCS HERX371C101 - Manual (Page 84)

CH. 13 MAN0924-01-EN
February 8, 2010 Page 84 of 124 # 1018
If communications are successful, the target indicator should show the mode of the controller Target:
yy(R) as shown in the status section above
Cscape Status Bar . (13.2)
If the controller is not communicating you may need to set the target ID of the controller in Cscape or on
the unit. The Target ID allows directing communications to a particular unit when multiple units are
connected via a CsCAN network. Units without CsCAN network ports respond to any network ID and do
not require the ID to be configured.
To check or change the ID on the RX-371 OCS, press the system menu key.
The first item in the menu is Set Network ID. Pressing Enter allows you to view or modify the ID of the
unit.