Horner APG RX371 OCS HERX371C101 - Manual (Page 101)

MAN0924-01-EN CH. 16
February 8, 2010 Page 101 of 124 # 1018
CHAPTER 16: SMTP (EMAIL) PROTOCOL
16.1 Overview
Electronic mail, often abbreviated as email or e-mail, is a method of exchanging digital messages,
designed primarily for human use. Email has been implemented using SMTP protocol in OCS.
An electronic mail message consists of two components, the message header, and the message body,
which is the email's content. The message header contains control information, including, an originator's
email address and one or more recipient addresses. Usually additional information is added, such as a
subject header field.
This feature is designed to send email messages embedding real time data (logic registers) of the
controllers and can be configured using Cscape.
Minimum version requirements for Email feature:
1. Firmware 12.6
2. Cscape 9
Refer Quick Start Guide (MAN0923) for stepwise configuration details.
This feature is available only in OCS that have inbuilt Ethernet port like the NX, RX and XL6e.
This feature:
- Supports login type authentication (TSL/SSL authentication servers are not supported)
- Allows upto 20 logic registers to be embedded per email.
- Supports upto 128 different emails to be configured.
NOTE: OCS cannot receive emails.
Email without attachments.
16.2 Configuration
Ethernet port configuration in Ethernet Module Enhanced Configuration is needed before configuring
Email feature.
16.2.1 Email Configuration
To open the Email Configuration dialog, Click on Program and then select Messaging | Email.
This will bring up the following dialog.
Select Enable Email Configuration to begin email configuration.