Red Lion GEMINI 52 - Manual (Page 5)

Pressing the “E” key finalizes the change. The display
will now show the rate value immediately.
If you do not press the “E” key, the change will not be
recorded. The display will remain in the programming mode
for 15 seconds, and then return to normal operating mode
using the old function and mode settings.
Whenever the Unit Personality is changed, the factory settings will
automatically be loaded into the unit. The factory settings can also be
programmed into the unit by calling up the Unit Personality, putting a “-” in front
of the mode by pushing the “+/-” key, and entering it.
Refer to the “Initial Factory Configuration” section for more details.
PROGRAMMING THE PRESETS, SCALE FACTORS &
TIMED OUTPUT VALUES
The Presets and Scale Factor Values are commonly reprogrammed on a daily
basis. As such, single keystroke access has been provided on the front panel.
The Gemini 5200 has two Scale Factors, one for Rate
Display A , and one for Rate Display B. Pressing the “3” key
will call up the Scale Factor for the current rate value being
displayed (Rate A or Rate B).
To call up the “other” Scale Factor, the “+/-” key is first pushed to change the
display to the “other” value (Rate A or Rate B), then the “3” key is pushed to
display the Scale Factor for that value.
Once the Scale Factor is displayed, changing the digits
can be accomplished by repeatedly pressing the key beneath
the digit position you wish to change or by holding the key
down, allowing the digit to cycle.
The new value will be entered when the “E” key is pressed.
The internal unscaled rate value is multiplied by the Scale Factor Value, which
changes the displayed value accordingly.
To display the Preset 1 Value, the “1” key is pushed.
To change the value, the digits can be cycled through in
the same manner as discussed for the Scale Factors. The
Preset Values can range from -999999 to +999999.
The new value will be entered when the “E” key is pressed.
The Timed Output Values are changed by entering
two-digit function codes. After the code is entered, the
display will show the present Timed Output 1 or 2 Value in
seconds with two decimal place resolution. The Timed
Output Values can be set from .01 to 599.99 seconds.
To change the Timed Output 1 Value, enter function code
53 and enter the new value by holding down or repeatedly
pressing the key below the digit position you wish to change.
The new value will be entered when the “E” key is pressed.
The display will immediately return to the rate value.
-3-