HP Insight Management Agents - Manual (Page 122)

• Mirrored Memory—This system is configured for Mirrored Memory Protection. All memory
banks are duplicated in Mirrored Memory, as opposed to only one for Online Spare Memory.
If enough ECC errors occur, the spare memory is activated and the memory experiencing
the errors is disabled.
• XOR—This system is configured for Advanced Memory Protection using the XOR engine.
• Memory Board—The slot in which the memory board or cartridge is installed.
— Other—The value is unsupported or could not be determined.
— Present—The board or cartridge has memory and is currently online.
— Absent—The board or cartridge is offline.
• Board Status—This provides the current status of the Advanced Memory Protection memory
board or cartridge. The following status values are supported:
— Other—The condition of this memory board or cartridge could not be determined.
— OK—The memory board or cartridge is operating normally.
— Degraded—The memory board or cartridge is in an error state. Check for correct memory
installation and that the board has been inserted properly.
• Total Board Memory—This value specifies the size of memory for this board or cartridge,
including memory seen by the OS and the memory used for spare, mirrored, or XOR
configurations.
• Memory in Use—This value specifies the size of memory for this board or cartridge as seen
by the OS.
• Advanced Memory Protection Condition—displays the current condition of the Advanced
Memory Protection subsystem. The following states are supported:
— Other—The system does not support fault tolerant memory or the Management Agent
cannot determine the state.
— OK—This system is operating normally.
— Degraded— The Advanced Memory Protection sub-system has been engaged. Schedule
server down time to replace the deactivated memory.
ROM Microcode Patches
This section displays the following information about ROM Microcode Patches:
• Patch ID—Displays the number of a particular microcode patch.
• Date—Displays the date of a patch's manufacture.
• Family—Specifies the valid family, model, and step that applies to a patch.
• Model—Displays the model number of a patch.
• Step—Displays the revision level of a patch.
General I/O Devices
This section displays information about the following I/O devices:
• Diskette Drives—This section lists and describes the device diskette drives.
• Serial and Parallel Ports—This section displays the serial ports and the parallel ports that
have been enabled for this unit, along with their corresponding I/O addresses.
The industry-standard addresses for parallel ports are as follows:
— Primary Port set to 378h
— Secondary Port set to 3BCh
The industry-standard addresses for serial ports are as follows:
— COM1 set to 3F8h
— COM2 set to 2F8h
122 Agent information