HP Insight Management Agents - Manual (Page 117)

Therefore, some work done by Windows NT on behalf of your application might be displayed
in other subsystem processes in addition to the privileged time in your process.
Processor Utilization
This window displays information about the system's processor utilization for different time
intervals.
The system processor bar graphs display the percentage of total possible system processor
utilization over the specified period of time. A bar graph is displayed for every processor installed
in the device. Use this graph to determine if the system processor is a performance bottleneck.
System Configuration
Auto Recovery
This section provides Automatic Server Recovery (ASR) configuration information, tells you
when the server was last reset, and allows you to modify pager settings. You can modify the
Status, ASR Reset Boot Option, Pager Status, Pager Dial String, and Pager Message settings.
The following items display on this window:
General Information
• ASR Condition—This value specifies the overall condition of the ASR. The following values
are possible:
— Other—ASR is not supported on server.
— OK—Last reboot was not an ASR reboot.
— Degraded—Last reboot was an ASR reboot but the ASR reset count less than the ASR
reset limit.
— Failed—ASR reset count is greater than or equal to the ASR reset limit.
• Status—Displays the status of ASR. The following values are possible:
— Enabled—ASR is enabled for this server.
— Disabled—ASR is disabled for this server. To change this status, run the System
Configuration Utility or perform a set on this item.
— Not Available—ASR is not available for this server or your driver is not loaded. ASR
is available only on operating systems using the ASR software support provided by
HP/Compaq.
— Unknown—You may need to upgrade your support software and/or Server Agent(s).
The Server Agent cannot determine the status.
• Last Reset—Displays how the last server reset was performed. The following values are
possible:
— ASR—The last reset was performed by ASR. Check the Critical Error Log to determine
what may have caused ASR.
— ASR-Cleared—The last reset was performed by ASR. The degraded condition caused
by the ASR reset has been cleared. Degraded ASR conditions can be cleared by selecting
the Clear ASR button on the Auto Server Recovery window.
— Manual—The last reset was performed manually.
— Unknown—You may need to upgrade your driver software and/or Server Agents. The
Server Agent cannot determine the status of the device. If the last reset was an ASR
reset, the ASR condition is degraded.
If the last reset was an ASR reset, the ASR condition is degraded.
Sub-system Classification 117