HP Insight Management Agents - Manual (Page 13)

NOTE: Notice that the URL is followed by 2301. This is the port or socket number that the
HP Insight Management Agents for Servers use to communicate with the browser. If this
number is not specified, your browser might attempt to connect to another Web page if the
managed server is running a Web Server.
NOTE: Notice that the URL is followed by 2381 which identifies secured way of accessing
the URL, which starts with https.
NOTE: Both the IP address 127.0.0.1 and the localhost are the same. They can be used
interchangeably.
After you enter the URL, the System Management Homepage appears.
Security
The HP Insight Management Agents allow SNMP sets for some system parameters. This capability
requires security that includes three users namely; Administrator, Operator and User. On
Windows and Linux operating systems only administrator can set SNMP sets. This can be
achieved by logging to System Management Home page using administrative access privileges."
NOTE: These are the only user accounts available in this release, and they cannot be changed
except for the password. Under Tru64 UNIX, the account names, user names, and passwords
are lowercase characters.
The Web-Enabled HP Management Agents for Servers for NetWare is located in the
WEBAGENT.INI
file in the SYS:\SYSTEM\CPQMGMT\WEBAGENT directory. It specifies the level
of user who has access to data. The “read=” and “write=” entries in the file set the user accounts
required for access, where:
• 0 = no access
• 1 = anonymous
• 2 = user
• 3 = operator
• 4 = administrator
Changing these entries changes the security level.
When the System Management Homepage is launched for the first time on operating systems
other than those from Microsoft and Linux, anonymous access to information is available without
logging in.
Deploying the configurations to servers running Microsoft® Windows®
On systems running Microsoft OS, anonymous access is disabled by default.
To turn on anonymous access, complete the following steps:
1. Open the System Management Homepage
2. Select Settings>SMH>Security>Anonymous/Local Access.
3. Select either of the following access types:
Deploying the configurations to servers running Tru64 UNIX
Under Tru64 UNIX, the location of the WEBAGENT.INI file depends on whether the Management
Agents for Tru64 UNIX were installed as part of the base operating system or as an upgrade.
You can determine the location of the WEBAGENT.INI file by issuing the following command:
The command output resembles one of the following lines:
# ps -ef | grep -i cpqthresh_mib | grep -v grep
Security 13