HP Insight Management Agents - Manual (Page 151)

Problems if the address 127.0.0.1 is not added to SNMP host list
The following problems occur only if the address 127.0.0.1 is not added to the SNMP host list if
SNMP host security is used in Windows® NT or Windows® 2000.
•
The following Event Log error messages appear:
The HP Foundation Agents service could not terminate agent "CPQMHOST." The data
contains the error code.
The HP Foundation Agents service could not start agent "CPQMHOST." The data contains
the error code.
• NIC information does not appear.
• Server Status Information appears incorrectly. For example, the Server Status information
is highlighted in green. However, when the customer drills down to mass storage, the Server
Status information is highlighted in red. Therefore, the upper-level view of the information
incorrectly displays the status of the server.
The customer must add the address 127.0.0.1 to the SNMP host list if SNMP host security is used.
The Management CD provides a utility that adds the address 127.0.0.1 to the host list if the
customer does not want to add it manually. The utility file is named lhost.exe and is located in
SP12205.
Missing ProLiant Storage System information
The ProLiant Storage System driver is not installed.
Verify that the ProLiant Storage System driver appears under the Devices Control Panel icon in
Windows NT 4.0. In Windows® 2000 select the Administrative Tools Control Panel icon and
then the Computer Management icon. The driver is shown under the System Devices in Device
Manager. If it is not listed, install it from the ProLiant Support Pack for Microsoft® Windows®
NT 4.0 or the ProLiant Support Pack for Microsoft® Windows® 2000.
ASR POST failure reported
This is caused by an older version of the Systems Management driver.
Upgrade the Systems Management driver from the latest version of the SmartStart CD.
Management Agents for Servers
The Windows® NT software has been tested with Microsoft® Internet Explorer 4.0 on
Microsoft®Windows® NT 4.0, and with Netscape Navigator 4.04 on Microsoft® Windows® NT
4.0.
The minimum browser requirements must be met for the to work correctly.
Depending on how they were implemented, some browsers might not work correctly when used
with different operating systems.
Other problems
Tape device error detected by Windows® backup
At startup, the Windows® backup application returns the following error message:
Tape Drive Error Detected
A tape drive has been detected and the tape driver has been started. However, the tape drive is
not responding. Be sure the tape device power is on and cables are properly connected.
This message appears if the SCSI Information Agent is collecting data from the tape drive while
the backup software is attempting to start (since only exclusive access to the tape drive is allowed).
If this message appears, perform the following steps:
1.
Select Operation>Hardware Setup.
2. Re-select the tape drive to use. If these actions do not eliminate the error message, the tape
drive might not be functioning properly.
Insight Management Agents for Servers issues 151