HP Compaq StorageWorks TL881 DLT Mini-Library - Manual (Page 90)

Installation 3-21
4 pieces 968313-101
b. If the module you are installing is going to be located third or fourth
from the top (unit 3 and 4), the parts which you will need to install
this module are:
2 pieces 968319-101
4 pieces 968320-101
c. If the module you are installing is going to be located fifth or sixth
from the top (unit 5 and 6), the parts which you will need to install
this module are:
2 pieces 968608-101
4 pieces 968609-101
d. Sort out the appropriate adapters for your application. The part
number is stamped in the middle of the part for identification.
3. Next to each mounting hole in the bracket, numbers are stamped which
correspond to the module number. If you are installing the first module
for example, mount the flat head screws (P/N 213164-108) through the
holes marked #1.
Metric Rackmount Procedure:
1. Refer to Figure 3-13, Metric Rackmount Installation Layout. Mount the
appropriate metric conversion bracket to both ends of the slide using the
10-32 nuts provided in the slide kit. Do this for both the left and right
slide assembly. For modules 1 and 2, use P/N 968313-101. For modules
3 and 4, use P/N 968320-101; for modules 5 and 6, use P/N 968609-101
Make sure that these brackets are oriented so that the numbers are right
side up in all corners.
2. Mounting the bracket/slide assembly to the StorageWorks cabinet:
If installing the first module, select a
mounting location:
a. Mount each slide/bracket assembly to the rack by aligning the two
mounting holes marked #1 to holes on the rack. Start by mounting
the slide/bracket assembly to the rear of the StorageWorks first.
Hold the bracket/slide assembly in place with one hand, fasten a
mounting screw to the holes marked #1.
b. To mount the front bracket, place bracket (P/N 968312-101) in front
of the rack with the holes marked #1 aligned to the holes on the rack.