HP Compaq StorageWorks TL881 DLT Mini-Library - Manual (Page 79)

3-10 Compaq TL881 Minilibrary System Users Guide
3. Locate the length of toothed belt that was enclosed with the extension
section.
Table 3-1
Belt Length for Various System Sizes
Number of Modules Length of Belt
2 27 inches
3 41 inches
4 55 inches
5 69 inches
6 83 inches
SHR-1237
Figure 3-5. Threading the Belt through the Drive Section
4. Refer to Table 3-1 for the required belt length for your system. After
double-checking the length specified, cut the belt between teeth.
5. With the toothed side of the belt toward you, position the right end of
the belt about halfway along the Pass-Thru mechanism.
6. Referring to Figure 3-5, thread the left end of the belt counter-clockwise
around the motor drive pulley.