HP Compaq StorageWorks TL881 DLT Mini-Library - Manual (Page 178)

Adding a Second Tape Drive D-3
Removing and Replacing the Skin Cover (Desktop
Models Only)
The skin cover is held in place by two screws on each side of the base module
(Figure D-2).
SHR-1433
Figure D-2. Removing the Skin Cover
Removing
Remove the skin cover from the base module as follows:
1. Remove the two screws on each side of the base module.
2. Grasp the cover by the sides at the bottom edge and pull outwards while
lifting the cover straight up and off the chassis.
Replacing
To replace the skin cover on the base module:
1. Position the skin cover over the base module with the two tabs the two
angled surfaces facing toward the front.
2. Slide the skin cover over the module until it touches the front panel.
3. Insert the two screws on each side through the skin cover into the base
module, but don’t tighten the screws until you have all four started.