HP Compaq StorageWorks TL881 DLT Mini-Library User Manual

Page 183

D-8 Compaq TL881 Minilibrary System Users Guide

Slide the drive (6) into the drive caddy assembly; position the drive so
the threaded holes in the top and bottom of the drive are aligned with the
screws holes.

Install the four 6-32 sems pan-head Phillips screws that were removed in
Step 1.

Connect the unused connector on the power Y-cable to the drive just
installed.

Connect the unused connector on the SCSI cable to the drive just
installed.

Install the RS-422 cable supplied with the kit, sliding it under the
clamps so that the connector is adjacent to the connector on top of the
new drive.

10.

Install the RS-422 cable removed in Step 3 over the top of the new RS-
422 cable so that the connector is adjacent to the connector on top of the
original drive.

11.

Connect the RS-422 cables to the connectors on the top of the drives,
through the holes in the top of the drive caddy assembly.

12.

Replace the drive caddy assembly as described in Removing and
Replacing the Drive Caddy Assembly.