HP Compaq StorageWorks TL881 DLT Mini-Library - Manual (Page 122)

Configuration 4-7
Custom and press Enter to accept this setting. To return the module to online
status, press Escape three times.
Set Element Base
This option allows you to set the base addresses of each of the three SCSI
elements of the module. In order to identify sources and destinations in
commands to the robotics, the base module is divided into elements, each of
which is assigned a separate designator or element address. The Transport
Element is the robotics mechanism itself; the Storage Elements are the 10 slots
in the magazine; the Transfer Elements are the drives. The Base Module
reports these settings in response to the SCSI Mode Sense command, in the
Element Address Assignment Page. The defaults are Transport = 0000h,
Storage element base = 0001h, Transfer element base = 00F0h.
Set Date
Enables you to set the module’s calendar.
The following tables, Table 4-1, MiniLibrary Configuration Options, and
Table 4-2, MiniLibrary Special Configuration Options summarize the
configuration settings for the Mini-Library Base Module.
NOTE: The options described in Table 4-1 and Table 4-2 represent the version of the
firmware in use when this manual was written. If the displays on your control panel differ
from those described here, you may find an up to date listing of configuration options on
the Compaq Website listed in the front of this manual.