HP Compaq StorageWorks TL881 DLT Mini-Library - Manual (Page 142)

Diagnostics and Troubleshooting 6-7
Table 6-2
Fault Symptom Codes
continued
SCSI Error Codes 1xxx
FSC Message Description
1001 SCSI Firmware Error
1002 SCSI FIFO Empty While getting SCSI command bytes,
the SCSI chip reported an empty FIFO
before it was expected.
1003 SCSI FIFO Error While getting SCSI command bytes,
the SCSI chip reported that the FIFO
was not empty when it should be
empty.
1004 SCSI Gross Error Gross error status was returned by the
SCSI chip. This usually means that the
SCSI chip is in an illegal state.
1005 Illegal SCSI Cnt Cmd The SCSI chip rejected a command
from the firmware.
1006 SCSI Message Error Not reported
1007 SCSI Invalid Element Firmware error
1008 SCSI No Pending Int An interrupt was returned from the
SCSI chip when one was not expected.
1009 SCSI Invalid Int An invalid interrupt was returned from
the SCSI chip.
1020 No Active Command Status was returned from the control
process when no command was
active.
1021 SCSI Invalid Request An invalid request was received from
the control process (firmware error).
1022 SCSI Invalid Semaphore Firmware Error
1023 SCSI Invalid State Firmware Error
1024 SCSI Invalid Ctl Msg A message sent from the control
process was not valid.
continued