beautypg.com

HP Compaq StorageWorks TL881 DLT Mini-Library User Manual

Page 145

background image

6-10 Compaq TL881 Minilibrary System Users Guide

Table 6-2
Fault Symptom Codes

continued

Control Error Codes – 2xxx

200F

Removal Prevented

Medium removal was attempted when
in a Prevent Removal State.

2010

Ctl Firmware Error

An invalid configuration was detected.
The configuration jumpers on the main
board may not be set properly.

2011

Ctl Firmware Error

A status block was received by the
Control Process operating in a Stand-
Alone or Slave configuration. Since
commands are never sent in these
modes, status cannot be received.

2012

Ctl Firmware Error

A command was received which was
invalid for the current configuration.

2013

Ctl Firmware Error

2014

Ctl Firmware Error

2015

Ctl Firmware Error

2016

Ctl Firmware Error

2030

DLT Timeout Error

During powerup, communication with
one of the DLT drives was
unsuccessful.

2031

DLT Timeout Error

While trying to update the front panel,
communication with one of the DLT
drives was unsuccessful.

2032

DLT Timeout Error

Communication with DLT drive 1 was
unsuccessful (sequential mode).

2033

DLT Timeout Error

Communication with DLT drive 2 was
unsuccessful (sequential mode).

2034

DLT Timeout Error

While attempting to update the
cartridge map, communication with
one of the DLT drives was
unsuccessful.

204x

Invalid Ctl Msg

An illegal message type code was
received. This can be the result of
receiving a NULL type code, a status
code without a command being active,
or a command code while a command
is currently active.

continued