HP Compaq StorageWorks TL881 DLT Mini-Library - Manual (Page 146)

Diagnostics and Troubleshooting 6-11
Table 6-2
Fault Symptom Codes
continued
FSC Message Description
205x No Free Queues The system could not allocate a free
queue.
206x Calib. Error Port x When trying to locate the unit attached
to port x, the pass-thru elevator
reached the top of rail.
206f Pass-thru Init Error The pass-thru elevator did not travel a
minimum distance to reach the top of
its travel.
2070 Command Timeout Enter to reboot. The ten minute timer
was exceeded when trying to fetch
from a drive.
2071 Command Timeout Internal error only. Not reported to the
operator or host.
2072 Command Timeout Power Down, Wait 30 seconds, Power
Up. Occurs if the power is cycled too
quickly and the DLT drive comes up in
an error state and doesn’t
communicate with the library
controller.
2073 Drive Config Error Set if the Alternate Unload has not
been selected. This currently applies
only to DLT7000’s with a controller
microcode revision greater than 50.
2074 Stow Error A stow timeout error has occurred
when accessing a remote unit. Press
Enter to Reboot for orphan cartridge
recovery.
2075 Fetch Error During a remote fetch operation, the
remote unit returned an error.
continued