HP Compaq StorageWorks TL881 DLT Mini-Library User Manual

Page 118

Configuration 4-3

SHR-1459

Figure 4-4. Drive Selection Submenu

Press the Enter button to select DLT0, or, to select DLT1, press the
button to move the

next to DLT1, then press the Enter button. A

submenu for the Set Data Format option shown in figure 4-5 appears:

SHR-1460

Figure 4-5. Set Data Format Submenu

As shown in the submenu in Figure 4-5, the

on the display is next to line 1,

and line 2 is indented. This tells you that Figure 4-5 is a two-tiered menu. The

and

buttons work on two levels in this kind of menu, which is typical of

many submenus of the Configure Menu. The first level is as follows: If you
press the

button, the

moves to line 3. Pressing the

button again has no

effect. If you press the

button, the

moves back to line 1.

If you press the

Enter

button while the

is next to line 1 (or line 3), the

and

buttons operate on the second level. You can tell because the

moves

next to line 2 (or line 4), and a

appears at the end of line 4, indicating that

there is a list of settings that can be scrolled using the

and

buttons.

Example:

To set the DLT1 Density would involve the following steps:

With the

next to line 1, press the Enter button, moving the

to line

2. Notice the

appears at the end of line 4.

Use the

and

buttons to scroll line 2 to display the possible settings.

After making your selection, press the Enter button to save the new
selection. You can return to the screen in Figure 4-5 by pressing the
Escape button. The

returns to line 1.

This time, if you press the

button instead of the Enter button, the

moves to line 3, allowing you to set DLT1 Compression.