HP Compaq StorageWorks TL881 DLT Mini-Library - Manual (Page 144)

Diagnostics and Troubleshooting 6-9
Table 6-2
Fault Symptom Codes
continued
Control Error Codes – 2xxx
2001 Ctl Invalid Command Ctl. Invalid Command
2002 Undefined Config An unsupported configuration was
detected.
2003 Invalid Drive State One of the DLT drives was in an invalid
state This is caused by either
attempting to fetch a cartridge from an
empty drive, or stowing to a drive that
already has a cartridge loaded.
2004 Loader Not Ready Currently not displayed.
2005 SCSI Id Not Set An attempt to set the DLT SCSI id
failed.
2006 DLT Comm Open Error An attempt to open a COM port failed.
2007 Door Fault An error occurred while attempting to
move the door.
2008 Illegal Move While attempting to perform a MOVE
operation, the source or destination
locations were in the wrong state
(FULL or EMPTY).This also occurs if
the MOVE is attempted with an invalid
cartridge map.
2009 Door Open A command was received while the
door was open.
200A Menu Mode A command was received while the
unit was in Menu mode.
200C Cart Unaccessible An attempt was made to fetch a
cartridge from a drive that is not in the
unloaded state. This only applies
when the system is configured for
explicit unloads.
200D Drive In Error An attempt was made to access a
drive which is in an error state.
200E No Magazine The element is not available because
the magazine is not installed.
continued