HP Compaq StorageWorks TL881 DLT Mini-Library - Manual (Page 89)

3-20 Compaq TL881 Minilibrary System Users Guide
1
7
8
3
2
9
10
6
5
4
4
6
5
SHR-1243
2
1
2
1
2
1
2
1
4
3
4
3
4
3
4
3
2 x 968312-101 4 x 968313-101
2 x 968319-101 4 x 968320-101
2 x 213164-108 2 x 972629-132
Figure 3-12. Parts List for StorageWorks Metric Rackmounting
1 Outer slide 6 Front
2 Intermediate slide 7 Mounting bracket
3 Inner slide 8 Nut plate;
4 Lock tab 9 For 1 st or 2 nd modules from top (units 1 and 2)
5 Rear - For 3 rd or 4 th modules from top (units 3 and 4)
NOTE: Brackets for modules 5 and 6 are not shown in Figure 3-12.
WARNING: The cooling fan at the rear of the drive must not be obstructed
when the drive is installed in the rack. It is advisable to allow two inches of
clearance behind the rear panel of the module.
Make certain that when the Module is fully extended that a force of 20% of the
rack weight, but not more than 57 lb. applied in any direction but upwards does
not cause the rack to overbalance.
Metric Conversion Bracket Description and
Identification:
1. Refer to Figure 3-12 to identify and take inventory of the metric
conversion hardware included in your metric rackmount kit.
2. Determine where the module you are installing is going to be located
relative to the top module.
a. If the module you are installing is going to be located on the top of
the stack or the second from the top (unit 1 or 2), the parts which you
will need to install this module are:
2 pieces 968312-101