HP Compaq StorageWorks TL881 DLT Mini-Library - Manual (Page 101)

3-32 Compaq TL881 Minilibrary System Users Guide
The settings can be changed using the procedure described in the section
entitled A Configuration Example - Setting the SCSI ID, covered later. Before
changing any configuration settings, consult your host system documentation
to determine which settings may need to be changed.
Setting MiniLibrary Base Module (slave)
Configuration
IMPORTANT: All MiniLibrary Base Modules are shipped configured as standalone
systems. Before powering up the Expansion Unit in a MiniLibrary system for the first time,
you must reconfigure each of the MiniLibrary Base Modules in the system as a slave. To
do so, perform the following procedure on each MiniLibrary Base Module.
1. Turn on the power switch on the MiniLibrary Base Module. After a
series of self-test screens, the screen shown in Figure 3-18 appears:
SHR-1473
Figure 3-18. MiniLibrary Base Module Default Screen
2. Press the Enter button to display the Main Menu, shown in Figure 3-19:
SHR-1331
Figure 3-19. MiniLibrary Base Module Main Menu
3. Press the button. three times to select the Configure Menu, then press
the Enter button. The screen shown in Figure 3-20 appears:
SHR-1332
Figure 3-20. Configure Submenu