HP OneView for VMware vCenter - Manual (Page 18)

4. Select HP XP P9000 in the Type list, and then click Next.
The Add HP XP P9000 storage systems page appears. The available P9000 storage systems
are listed by serial number.
5. Select a storage system.
6. Enter the Remote Web Console credentials, and then click Finish.
The array is added to the Configured Storage Systems and Management Servers list.
NOTE: The HP XP P9000 storage system does not support provisioning by the Storage
Module for vCenter.
Adding HP XP storage systems
To add an HP XP storage system:
1.
Verify that a command device from the XP array is presented to the host running the Storage
Module for vCenter.
2. Access the Storage Administrator Portal.
For instructions, see “About the Storage Administrator Portal” (page 12) .
3. Click Add.
The Add Storage System or Management Server page appears.
4. Select HP XP in the Type list, and then click Next.
The Add HP XP storage systems page appears. The available HP XP storage systems are listed
by serial number.
5. Select a storage system.
6. Enter the Remote Web Console credentials, and then click Finish.
The storage system is added to the Configured Storage Systems and Management Servers
list.
NOTE: The HP XP storage system does not support provisioning by the Storage Module for
vCenter.
Adding HP StoreOnce Backup
To add an HP StoreOnce Backup:
1.
Access the Storage Administrator Portal.
For instructions, see “About the Storage Administrator Portal” (page 12) .
2. Click Add.
The Add Storage System or Management Server page appears.
3. Select HP StoreOnce Backup in the Type list, and then click Next.
The Add HP StoreOnce Backup page appears.
4. Enter the following connection information for the HP StoreOnce Backup array you want to
add, and then click Next.
•
Management server host name or IP address
•
User name
•
Password
A summary of the information is displayed.
18 Configuring Insight Control for vCenter