HP XP RAID Manager Software - Manual (Page 61)

Cause of error RAID Manager command SSB2
You cannot create the pair because the SS P-VOL and BC/SS S-VOL share the
volume, and the BC/SS S-VOL you specified for the SS P-VOL has consistency
group settings. paircreate 9778
The command ends abnormally because the SS P-VOL and BC/SS P-VOL share
the volume, and the BC/SS pair was in the process of resynchronization. paircreate, pairsplit 977a
The command ends abnormally because the SS P-VOL and BC/SS S-VOL share
the volume, and BC/SS pair status is not “PSUS”. paircreate, pairsplit 977b
The command ends abnormally because the SS P-VOL and BC/SS P-VOL share
the volume, and BC/SS pair status is not “PSUS” or “PSUE”. pairresync -restore 977c
The command ends abnormally because the SS P-VOL and BC/SS S-VOL share
the volume, and BC/SS pair status is not “PSUS”. pairresync -restore 977d
SS data cannot be stored because the pool or the pool-VOL is blocked. pairsplit 977e
The pair cannot be restored for one of the following reasons: pairresync -restore 9783
•
The pair’s snapshot you want to restore is stored in a consistency group.
• The pair’s P-VOL you want to restore is used as the P-VOL for another SS pair,
and the SS data of the latter pair is stored in a consistency group.
The command ends abnormally because quorum disks are specified as P-VOLs
of SS pairs. paircreate, pairsplit,
pairresync, pairresync
-restore 9786
The command ends abnormally because quorum disks are specified as S-VOLs
of SS pairs. paircreate, pairsplit,
pairresync, pairresync
-restore 9787
The pair cannot be created using the consistency group number for one of the
following reasons: paircreate 978a
• The specified consistency group number is in use for BC/SS.
•
The number of pairs has already exceeded the maximum number of pairs
that can be created for one consistency group.
• A pair that uses the same P-VOL exists already in the specified consistency
group.
You cannot create the pair because the specified consistency group number is
out of the range of the number that can be specified. paircreate 978b
SS data cannot be stored because the Cnt Ac-S asynchronous pair status is other
than “PSUS” or “PSUE” when SS (P-VOL) and Cnt Ac-S asynchronous (S-VOL)
share the volume. pairsplit 978c
You cannot create the pair for which you specified the consistency group. The
P-VOL or S-VOL of the BC/SS pair is already specified as the P-VOL of the SS
pair. paircreate 978e
You cannot create the pair because you specified a THP V-VOL that is undergoing
capacity expansion as the SS P-VOL. paircreate 9790
You cannot create the pair because you specified a THP V-VOL that is reclaiming
zero pages as the SS P-VOL. paircreate 9793
The command ends abnormally because you specified a volume without path
definition as the SS P-VOL. paircreate, pairsplit,
pairresync, pairresync
-restore 9796
The command ends abnormally because you specified a volume without path
definition as the SS S-VOL. paircreate, pairsplit,
pairresync, pairresync
-restore 9797
If you have already made the maximum number of SS pairs, you cannot create
new pairs. paircreate 97A1
Troubleshooting with RAID Manager 61