25 system, Parameter, Settings – HP XP External Storage Software User Manual
Page 117: Thunder, 9500v, Storage, System)

Table 25 System Parameter Settings (Thunder 9500V Storage System)
Window Names
Parameters
Parameter Settings
System Startup
Settings
Start Attribute
•
Single Mode
Specify this parameter when Thunder
9500V storage system is in the one
controller configuration.
•
Dual Active Mode
Specify this parameter when Thunder
9500V storage system is in the two
controller configuration.
Note:
Be sure to specify that Data Share
Mode will be used.
•
Hot Stand-By Mode
Do not specify this parameter.
Common 1
Delay Planned Shutdown
You can either specify this parameter or
omit specifying this parameter.
OPTION 1
SCSI Fibre Channel Common
Options
You can either specify this parameter or
omit specifying this parameter.
OPTION 2
SCSI Fibre Channel Common
Options
You can either specify this parameter or
omit specifying this parameter.
Data Striping
Operation if the processor failure
occurs
Specify this parameter to Reset of
occurred.
Command Queuing Mode
Specify this parameter ON.
Vendor ID
Keep this parameter as HP (default), and
do not change.
Product ID
Keep this parameter as DF600F (default),
and do not change.
Inquiry Setting
ROM Microcode Version
You can either specify this parameter or
omit specifying this parameter.
RAM Microcode Version
You can either specify this parameter or
omit specifying this parameter.
WEB Title
You can either specify this parameter or
omit specifying this parameter.
Reset/LIP Mode
•
Reset/LIP Mode (Signal)
You can either specify this parameter or
omit specifying this parameter.
Port Type
•
Reset/LIP Mode (Process)
You can either specify this parameter or
omit specifying this parameter.
•
LIP Reset Mode
You can either specify this parameter or
omit specifying this parameter.
Controller Option
RS232C Error Information Outflow
Mode
You can either specify this parameter or
omit specifying this parameter.
Write and verify mode
Set this parameter to ON.
Host Connection
Mode
Host Connection Mode 1
Set this parameter to Standard Mode.
Host Connection Mode 2
Specify HISUP Mode.
Note:
Do not specify any other
parameters.
XP24000 External Storage Software User’s Guide
117