HP Insight Cluster Management Utility - Manual (Page 147)

EXAMPLES
Command-line mode:
# /opt/cmu/bin/cmu_add_node -H cn0006 -I 16.16.184.116 -M 255.255.254.0 -A 00-02-A5-52-EB-F8 -L default -G
192.168.0.1 -T ILO -R x86_64
processing 1 node ...
Interactive mode:
In interactive mode, you are prompted for node parameters:
# /opt/cmu/bin/cmu_add_node -i
hostname> n10
ip address> 16.16.184.116
netmask> 255.255.248.0
mac address> 00-1C-C4-79-35-83
architecture> x86_64
mgtcard> ILO
mgtcard ip address> 16.16.188.116
processing 1 node ...
Adding multiple nodes using a file:
The input file must have one line per node. Where one each line:
#1 is the hostname
#2 is the IP address
#3 is the netmask
#4 is the ethernet mac address
#5 is the active logical group (usually "default")
#6 is the management IP address or 0.0.0.0 if None
#7 is the management card type (e.g. ILO, lo100i, ILOCM, or None)
#8 is the architecture (ex. x86_64)
#9 is the cartridge number/metadata number (ILOCM and user-defined BMCs only)
#10 is the node number (ILOCM and user-defined BMCs only)
# cat nodes.txt
cn0001 16.16.184.116 255.255.254.0 00-02-A5-52-EB-F8 192.168.0.1 ILO x86_64
cn0002 16.16.184.117 255.255.254.0 00-02-A5-52-EB-F9 192.168.0.2 ILO x86_64
cn0003 16.16.184.118 255.255.254.0 00-02-A5-52-EB-FA 192.168.0.3 ILO x86_64
cn0004 16.16.184.119 255.255.254.0 00-02-A5-52-EB-FB 192.168.0.4 ILO x86_64
# /opt/cmu/bin/cmu_add_node -f nodes.txt
processing 4 nodes...
147