HP StorageWorks XP Remote Web Console Software User Manual
Page 180
6.
Select one from the DKCs (DKC-1 to DKC-4).
Notes:
•
The word "DKC" represents a storage system.
•
To register journal groups of the supervisor DKC, move on to step
after this step.
7.
Enter the serial number of the storage system. If the serial number is already displayed and
unchangeable, you do not need to enter it.
8.
Enter the LDKC number. If the LDKC number is already displayed and unchangeable, you do
not need to enter it.
9.
Select the control ID.
10.
Specify the LDKC number and the LDEV number of the remote command device.
NOTE:
If the LDKC number and the LDEV number are already specified and unchangeable,
you do not need to specify them.
11.
From the JNLG list on the left, select one or more journal groups that you want to register.
12.
Select ->Add.
The selected journal groups move to the JNLG list on the right.
NOTE:
If the JNLG list on the right contains any journal group that you do not want to register,
select the journal group from the list and then click <-Cancel.
13.
From Mirror ID, select a mirror ID.
NOTE:
If a mirror ID is already specified and unchangeable, you do not need to select it.
14.
If necessary, repeat steps 6–13 beginning on page
15.
Select Set to close the Add JNL Group window.
16.
See the Preview list to check the settings that you have made.
NOTE:
To modify a setting, select and right-click the setting in the Preview list and then
select Modify. A window appears and allows you to modify the setting.
17.
Select Apply to register journal groups.
NOTE:
If an error occurs, the rightmost column of the Preview list displays the error code.
To view detailed information about the error, right-click the error code and then select Error
Detail. An error message appears and gives you detailed information about the error.
Figure 83 Add JNL Group Window
180 Using Extended Consistency Groups