beautypg.com

Deleting logical paths – HP StorageWorks XP Remote Web Console Software User Manual

Page 105

background image

9.

See the Preview list to check the settings that you have made.

To modify a setting, select and right-click the setting from the Preview list and then select
Modify. A window appears and allows you to modify the setting.

To cancel a setting, select and right-click the setting in the Preview list and then select
Cancel.

10.

Select Apply to apply the settings that you have made. If an error occurs, the rightmost column
of the Preview list displays the error code. To view detailed information about the error,
right-click the error code and then select Error Detail. An error message appears and gives
you detailed information about the error.

Figure 52 Add Path Window

The Add Path window displays the following:

Port: allows you to select an initiator port on the local storage system. When specifying a
port, you can use the keyboard to enter the port number. When you enter the port number,
you can abbreviate the port number into two characters. For example, you can enter 1A
instead of CL1-A. You can use uppercase and lowercase letters.

Pair-Port: allows you to select an RCU target port on the remote storage system.

Set: closes the Add Path window and adds the settings to the Preview list.

Cancel: cancels the settings.

Deleting Logical Paths

Before deleting logical path(s), make sure that the remaining number of logical paths will be greater
than the minimum number of paths setting. The delete path operation will fail if the number of
remaining paths is equal to or less than the minimum number of paths.

To delete logical path(s), follow the procedure below. Not only the primary storage system
administrator but also the secondary storage system administrator can perform this operation:

1.

Ensure that the XP Remote Web Console main window is in Modify mode.

For detailed information about how to do this, see XP Remote Web Console user’s guide.

2.

Ensure that the DKC Operation window is displayed.

3.

In Display, select DKC.

Deleting Logical Paths 105

This manual is related to the following products: