HP StorageWorks XP Remote Web Console Software - Manual (Page 108)

Table 25 Logical Path Status (continued)
Remarks Status
An error occurred with initialization of connection between the local and the
remote storage system. The probable causes are:
No cable is connected to the local storage system.
No cable is connected to the remote storage system.
No cable is connected to the network device that comes between the local and
the remote storage system.
Initialization Failed
This status indicates one of the following:
A timeout error has occurred between the primary and the secondary storage
systems.
A logic error is detected between the primary and the secondary storage systems.
Communication Time
Out
The local storage system rejected the function for configuring logical path
connection. All logical path resources in the local storage system might be used
for other connections. Resource Shortage
(Port)
The remote storage system rejected the function for configuring logical path
connection. All logical path resources in the remote storage system might be
used for other connections. Resource Shortage
(Pair-Port)
The serial number of the storage system connected to this logical path does not
match the serial number specified by the Add DKC window. Serial Number
Mismatch
The port is not an initiator port. Invalid Port
This status indicates one of the following:
The specified port number is incorrect.
The port in the remote storage system is physically disconnected from the local
storage system.
Pair-Port Number
Mismatch
The port on the remote storage system is not an RCU target port. Pair-Port Type
Mismatch
A communication timeout error has occurred on the path between the primary
and the secondary storage systems. Communication Failed
Removing the Relationship Between the Primary and the Secondary Storage
Systems
To remove the relationship between the primary and the secondary storage systems and then
remove all the logical paths between the two storage systems. both the primary storage system
administrator and the secondary storage system administrator must perform this operation:
1. Make sure that all affected URz volume pairs have been deleted.
2. Ensure that the XP Remote Web Console main window is in Modify mode.
3. For detailed information about how to do this, see XP Remote Web Console user’s guide.
4. Ensure that the DKC Operation window is displayed.
5. In Display, select DKC.
6. Select LDKC from the tree.
7. The list displays a list of remote storage systems.
8. Select and right-click remote storage system(s) from the list.
9. Select DKC Operation and Delete DKC from the pop-up menu.
10. A confirmation message appears.
11. Select OK to close the message.
108 Configuring Disk Storage Systems and Logical Paths