HP StorageWorks XP Remote Web Console Software - Manual (Page 127)

An error occurred with the URz pair for delta resync operation. Hold(Failure)
Neither journal volumes nor data volumes are registered in this journal group. Blank
◦ S/N(LDKC): Indicates the serial number and the LDKC number of the remote storage
system.
This column is blank if the attribute of the journal group is neither Master nor Restore.
◦ Pair JNLG: Indicates the number of a journal group in the remote storage system.
This column is blank if the attribute of the journal group is neither Master nor Restore.
◦ Controller ID: Indicates the controller ID (model name that indicates the model) of the
remote storage system.
This column is blank if the attribute of the journal group is neither Master nor Restore.
◦ Path Watch Time: Indicates the time for monitoring blockade of paths to the remote storage
system. If the status of the mirror where secondary data volumes in local storage system
are registered is Hold or Hold(Failure), this column will be blank.
◦ Volume: Indicates the number of data volumes that are registered in the mirror.
◦ Capacity: Indicates the total capacity of data volumes that are registered in the mirror.
•
Previous: Displays detailed information about the previous journal group.
•
Next: Displays detailed information about the next journal group.
•
Close: Closes the JNL Group Detail window.
Changing Options for a Journal Group
To change options for a journal group, follow the procedure below. Both the primary storage
system administrator and the secondary storage system administrator must perform this operation:
1. Ensure that the XP Remote Web Console main window is in Modify mode.
For detailed information about how to do this, see XP Remote Web Console user’s guide.
2. Ensure that the Journal Operation window is displayed (see Changing Options for a Journal
Group .
3. Do either of the following:
•
In the tree, right-click a journal group from below Registered and then select JNL Groups
and Change JNL Option from the pop-up menu.
•
In the upper-right list, right-click the desired journal group and then select JNL Groups
and Change JNL Option from the pop-up menu.
CAUTION: You can select Change JNL Option only when one of the following conditions is
satisfied:
•
The attribute of the journal group is Initial.
•
The status of the journal group is Active.
•
The status of the journal group is Stop.
•
The status of the journal group is Hold.
•
The status of the journal group is Hold(Failure).
When one journal group uses multiple mirror IDs, whether you can or cannot select Change
JNL Option depends on the status of the journal group whose mirror is not in Hold or
Hold(Failure) status.
Changing Options for a Journal Group 127