HP StorageWorks XP Remote Web Console Software - Manual (Page 102)

12. See the Preview list to check the settings that you have made.
•
To modify a setting, select and right-click the setting from the Preview list and then select
Modify. A window appears and allows you to modify the setting.
•
To cancel a setting, select and right-click the setting in the Preview list and then select
Cancel.
13. Select Apply to apply the settings that you have made. If an error occurs, the rightmost column
of the Preview list displays the error code. To view detailed information about the error,
right-click the error code and then select Error Detail. An error message appears and gives
you detailed information about the error.
Figure 50 Add DKC Window
The Add DKC window displays the following information:
•
S/N: allows you to enter the five-digit serial number of the remote storage system.
•
LDKC: allows you to enter the LDKC number of the remote storage system. “00” is displayed
when the remote storage system is XP12000/XP10000/SVS 200 Disk Array. The LDKC#01
cannot be used in this version.
•
Controller ID: allows you to enter the controller ID (model name that indicates the model) of
the remote storage system. The controller ID for an XP storage system is 4.
•
Path Gr. ID: allows you to enter the path group ID. Path group IDs are used for identifying
groups of logical paths. One path group can contain up to eight logical paths.
Path group IDs are within the range of 1-FF (hexadecimal). If you select the Default check box,
the default path group ID will be set. In the current version, you cannot enter path group IDs.
Also, you cannot clear the Default check box. The number of path group IDs per one remote
storage system is always 1
102 Configuring Disk Storage Systems and Logical Paths