Dwyer UXF3 - Manual (Page 70)

- 66 -
[START] button..............................Starts the measurement of the selected device ( ;).
[Stop] button...................................Stops the measurement.
[Save as CSV] button .....................Saves the measurement data of each device in a file in CSV format.
On clicking the button, you are asked where to save the data as well as the
name of the file. Enter the place to save data and the name of the file, and a file
in CSV format is created.
[Check ON/OFF] check button ......Check the check box ( ;) to select all the items. (The check boxes for all the
items are checked ( ;)). Keep the check box blank (†) to cancel the selection
of all the items. (The check boxes for all the items are made blank ( †).
Note: The maximum number of data that can be saved is 65530. If read-in is attempted exceeding 65530, the
oldest data is deleted and the newest data is saved as the 65530th data.
1 Up to 65530 data Exceeding 65530 Data sort
2 Oldest data Delete Oldest data
Data (n–65529) Data (n–65529)
65529 Data (n–1)
65530 Newest data Newest data (n) Newest data (n)
Read-in data
Table 9-20 < PV Setting >
Item Content
DISPLAY 1 Select from VELOCITY, FLOW RATE, + TOTAL (ACTUAL), – TOTAL (ACTUAL), +
TOTAL PULSE, – TOTAL PULSE, RAS.
DISPLAY 2 Same as the selection of DISPLAY 1
CYCLE Enter in range of 1 to 60 sec.
Bulletin F-107-UXF3-S