Dwyer UXF3 - Manual (Page 51)

- 47 -
Table 9-6 < Range Setting >
Item Content
RANGE UNIT Select from L/s, L/min, L/h, L/d, kL/d, ML/d, m
3
/s, m
3
/min, m
3
/h, m
3
/d, k m
3
3/d, M m
3
/d,
BBL/s, BBL/min, BBL/h, BBL/d, kBBL/d, MBBL/d [ft
3
/s, ft
3
/min, ft
3
/h, ft
3
/d, kft/d,
Mft
3
/d, gal/s, gal/min, gal/h, gal/d, kgal/d, Mgal/d, BBL/s, BBL/min, BBL/h, BBL/d,
kBBL/d, MBBL/d]* Of which [ ]: unit is in case of inch system.
RANGE TYPE Select from SINGLE, AUTO 2, BI-DIR, BI-DIR AUTO 2.
FULL SCALE 1 Enter 0, ±0.3 to 32 m/s fitting value (comply with range unit).
FULL SCALE 2 Enter 0, ±0.3 to 32 m/s fitting value (comply with range unit).
HYSTERISIS Enter in the range of 0.00 to 20.00%. (2 places after decimal point)
OUTPUT LIMIT LOW Enter in the range of -20 to 0%.
OUTPUT LIMIT HIGH Enter in the range of 100 to 120%.
OUTPUT BURNOUT Select from NOT USED, HOLD, UPPER, LOWER, ZERO.
BURNOUT TIMER Enter in the range of 0 to 900sec.
RATE LIMIT Enter 0 to 5 m/s fitting value (comply with range unit).
RATE LIMIT TIMER Enter in the range of 0 to 900 sec.
Table 9-7 < Damping >
Item Content
DAMPING Enter in the range of 0.0 to 100.0 sec. (1 place after decimal point)
Table 9-8 < Low Flow Rate Cut >
Item Content
CUT OFF Enter 0 to 5 m/s fitting value (comply with range unit).
Table 9-9 < Output Correction >
Item Content
ZERO Enter –5 to 5 m/s fitting value (comply with range unit).
SPAN Enter in the range of ±200.00%. (2 places after decimal point)
Table 9-10 < Operation Mode >
Item Content
OPERATION MODE Select from NORMAL, HIGH SPEED.
Bulletin F-107-UXF3-S