Dwyer UXF3 - Manual (Page 53)

- 49 -
Table 9-11 < Total Setting >
Item Content
TOTAL MODE Select from TOTAL STOP, TOTAL RUN, TOTAL RESET.
TOTAL UNIT Select from mL, L, m
3
, km
3
, Mm
3
, mBBL, BBL and kBBL, [ft
3
, kft
3
, Mft
3
, kgal, gal,
mBBL, BBL, kBBL and ACRf]* Of which [ ]: unit is in case of inch system.
TOTAL RATE Enter in the range of 0 to 99999999 fitting value. (comply with total unit)
TOTAL PRESET Enter in the range of 0 to 99999999 fitting value. (comply with total unit)
OUTPUT BURNOUT Select from NOT USED and HOLD.
BURNOUT TIMER Enter in the range of 0 to 900 sec.
Note: When unit is changed, each unit indication of constant and total preset is changed if [Read] is executed.
Note: When setting of the unit, constant, total preset, and pulse withe is changed, it should be executed with the
mode stop.
Bulletin F-107-UXF3-S