Dwyer UXF3 - Manual (Page 33)

- 29 -
The address data indicated below is not stored in the main unit.
Relative
address
Register
No.
Data
type
Parameter Read-out data/Write-in data setting range Remarks
0150 40337 int Set value storage request
Read-out data: 0: Completed, 1: Being stored
Write-in data : 1: Storage
0152 40339 int Memory initialize
Read-out data: 0
Write-in data : 100: Initialize
Communication
is disabled for
about 5 seconds
after
initialization.
0154 40341 int Output setting (current check) Decimal point fixed, 20 to 120%
0156 40343 int Total pulse check Decimal point fixed, 1 to 100PULSE/s
0158 40345 int DO check 0: ON, 1: OFF
015A 40347 int DI check
Read-out data: 10: ON, 20: OFF
Write-in data : 0: Not use, 1: Start
015C 40349 int Test mode 0: Not use, 1: Set
015E 40351 int Input data Decimal point fixed, ±120%
0160 40353 int Tracking time Decimal point fixed, 0 to 900sec
0162 40355 int LCD & LED check *3 0: Not use, 1: Check
0164 40357 int Key test *3
Read-out data: 10: No key pressing, 20: ESC
key, 40: UP key, 80: ENT key, 100: SET key
Write-in data : 0: Not use, 1: Start
0166 40359 int Test cancel
Read-out data: 0: Termination, 1: Being tested
Write-in data : 0: Termination
Cancellation of
testing of
current, total
pulse, DO
check and test
mode
0168
to
0170
40361
to
40369
int
Not use, write-
in inhibited.
*3) No response is made if execution is attempted in a screen other than measure screen.
Bulletin F-107-UXF3-S