Dwyer UXF3 - Manual (Page 56)

- 52 -
9.11 Display Setting
Click the “DISPLAY” button on the Menu screen, and the following screen appears.
Fig. 9-18 < Display setting screen >
To select an item to be set or read, set the relevant check box to ON ( ;). Not to select (or to reset the selection),
set the relevant check box to OFF ( †). For details of “Display setting,” refer to Table 9-14.
Ɣ Display 1, 2 selection: In case of velocity, + total pulse, – total palse
Display invalid................... Decimal point
[Setting]....................... Sends the setting of the selected item (check box set to ON ( ;)), reflecting the response
value on the setting.
[READ] ....................... Reads the setting of the selected item (check box set to ON ( ;)), reflecting the response
value on the setting.
[Save] .......................... Reflects the setting sent by pressing the [Setting] button on the flowmeter flow transmitter.
Be sure to press the [Save] button if the setting is changed.
[Check ON/OFF]......... Set the check box to ON to select all the items (to set all the check boxes to ON ( ;)). Set
the check box to OFF ( †) to release the selection of all the items (to set all the check boxes
to OFF ( †)).
Bulletin F-107-UXF3-S