Dwyer UXF3 - Manual (Page 52)

- 48 -
9.9 Total Setting
Click the “TOTAL” button on the Menu screen, and the following screen appears.
Fig. 9-16 < Total setting screen >
To select an item to be set or read, set the relevant check box to ON ( ;). Not to select (or to reset the selection),
set the relevant check box to OFF ( †). For details of “Total setting,” refer to Table 9-11 on the next page.
Ɣ Mode: in case of start and reset;
Display invalid................... Unit, constant, total preset, pulse width
Ɣ Mode: in case of stop;
Display valid...................... Unit, constant, total preset, pulse width
[Setting]....................... Sends the setting of the selected item (check box set to ON ( ;)), reflecting the response
value on the setting. Note that only when “STOP” mode is selected, the setting of unit,
constant, total preset, pulse width is reflected.
[READ] ....................... Reads the setting of the selected item (check box set to ON ( ;)), reflecting the response
value together with the unit on the setting.
[Save] .......................... Reflects the setting sent by pressing the [Setting] button on the flowmeter flow transmitter.
Be sure to press the [Save] button if the setting is changed.
[Check ON/OFF]......... Set the check box to ON ( ;) to select all the items (to set all the check boxes to ON (;)).
Set the check box to OFF ( †) to release the selection of all the items (to set all the check
boxes to OFF ( †)).
Bulletin F-107-UXF3-S