GW Instek GDS-3000 Series Programming Manual - Manual (Page 97)

COMMAND DETAILS
97
Go_NoGo Commands
Note: The Go_NoGo and Template commands can only be used
with firmware version V1.19 or later. In addition, the GoNoGo APP
must first be launched (or use the command, “:GONogo:SCRipt”)
before any of the Go_NoGo or Template commands can be used.
:GONogo:CLEar .......................................................... 97
:GONogo:EXECute ..................................................... 98
:GONogo:FUNCtion ................................................... 98
:GONogo:NGCount .................................................... 98
:GONogo:NGDefine ................................................... 98
:GONogo:SOURce ...................................................... 99
:GONogo:VIOLation ................................................... 99
:GONogo:SCRipt .......................................................100
:TEMPlate:MODe ......................................................100
:TEMPlate:MAXimum ................................................100
:TEMPlate:MINimum ................................................101
:TEMPlate:POSition:MAXimum ................................101
:TEMPlate:POSition:MINimum ................................101
:TEMPlate:SAVe:MAXimum ......................................102
:TEMPlate:SAVe:MINimum ......................................102
:TEMPlate:TOLerance ................................................102
:TEMPlate:SAVe:AUTo ...............................................102
:GONogo:CLEar
Set
Description Clears the Go/NoGo counter.
Syntax :GONogo:CLEar